Maximize the protection of your outfitter tent's stove jack with the Cabela's® Ultimate Alaknak™ Outfitter Tent Roof Panel Protector. Made of a spark-resistant 150D polyester, this panel covers the area around the stove jack to help prevent hot embers from damaging the roof fabric. Easy to install design anchors securely with tie down lines and buckle anchors. Imported.
Adds extra protection to Ultimate Alaknak Outfitter Tent roof
Covers the area around the stove jack - shields roof from hot embers
Spark-resistant 150D polyester panel
Easy to install - tie down lines and buckle anchors. Imported.
Rated 1 out of
Can't Figure it outPurchased the panel protector.... No installation instructions nothing on YouTube either to figure it out..... Product will not fit back in bag as well. Total waste of money and want to return.
Date published: 2019-10-28
Rated 5 out of
Needed accessory.Works great for protection of sparks and creosote. Couldnt be any easier to lnstall. Just snap in place before raising the corner of the tent.
Date published: 2019-10-03
Rated 5 out of
Excellent ProtectionWhen using a wood stove in your tent , make the move and get the roof protector , it,s cheaper than a new tent, make sure your stove pipe is a safe height about the stove ring to help avoid sparks dropping on the roof and use a chimney cap with spark arrester for added safety, this cover will help a lot and not hard to set up , put it on the roof before you set up the tent, it,s a lot easier.
how do you install this as there is no instructionsthomas67
Asked by: thomas67
Thank you for choosing Bass Pro Shops.
During set up of the actual tent – the roof protector needs to be attached to the metal ring on the top peak of the tent as shown below.
The buckles need to be attached next before the big actual tent is erected and set up.
Then the roof protector just drapes down over the side of the tent. The hole goes over the smoke stack coming thru the tent roof and the edges of the roof protector are held along the edge of the tent with the grommet on the webbing tab coming off the roof protector to the tip of the sidewall tent pole. The tent pole guy out lines then go over the pole tip anchoring the roof protector to the roof.