Wheeler Engineering AR Bolt Catch Install Punch Kit

No gunsmith's arsenal is complete without the Wheeler Engineering® AR Bolt Catch Install Punch Kit. Punches are crucial to start the bolt-catch roll pin easily on your AR-15 and finish the installation with perfect, flush alignment. This punch kit includes 2 steel 3/32" punches with 1 counter-bored tip to start roll pins and 1 with an indexing tip to finish roll pins. These punches are flat on one side for proper alignment and rubber over-molded for a non-marring surface to protect your firearm.
Manufacturer model #: 710906.

• 2 steel 3/32" punches
• 1 counter-bored tip to start and align pins
• 1 indexing tip for finishing pins
• Rubber over-molded for non-marring surface