This SKU table contains a list of all SKUs available for the product. You can filter the list of items shown by selecting attributes.
Description
MEC Powder Bushing
MEC offers an assortment of MEC Powder Bushings to accommodate various loads and most powders for shotshell reloading. To change the amount of powder dropped, simply remove the powder bushing and replace it with a bushing with larger or smaller hole, as appropriate. The size of the bushing is identified by a number stamped on the outer surface. These bushings will work with both single stage and progressive charge bars. Made of aluminum.
Measure a consistent amount of powder every time
For use with MEC single stage and progressive shotshell press charge bars
Aluminum construction
Web ID: 1108311
Reviews
Rated 5 out of
5 by
ForestTec from
MEC out stanging reloading gearIf you are reloading shot shells MEC has what you need. I have always found MEC bushing chart to be a little conservative on what the actual powder charge will be thrown from their bushings. Almost always have to use the next larger bushing to get desired charge. You can always use nail polish or other means to diminish capacity if the bushing throws to heavy of a charge. Always clean your bushing with alcohol before using and check powder charge with scale too.
Date published: 2017-05-23
Rated 5 out of
5 by
flyfisher8 from
1200 :bushing gave the stated powder for 1200 ft/sec vol
Date published: 2016-06-21
Rated 5 out of
5 by
DickDastardly from
Exactly rightThese bushings are exactly right for my use.
Date published: 2015-07-28
Rated 5 out of
5 by
Citori51 from
Mec bushingsThese bushings are always close to size. If not
adjustment is with fingernail polish to make them smaller, or a reamer from the bottom to make them bigger.
Date published: 2015-01-06
Rated 3 out of
5 by
AnthonyRM from
MaterialI wish that bushing manufacturers would use something other than Aluminum for the bushings. My reloading area is not climate controlled and I get large swings in temperature therefore in the size of the bushing, as much as a grain.
There are several thermoplastics that are not as temperature sensitive as Aluminum. If I had a lathe I'd do it myself.
Date published: 2014-12-30
Rated 5 out of
5 by
4theday from
PerfectGreat Price and with flat rate shipping, Cheaper than driving to the store.
Date published: 2013-10-15
Rated 4 out of
5 by
easygo3 from
MEC bushingThere's not too much to say about a MEC powder bushing. It is what it is. I only gave 4 stars, and wouldn't recommend purchase from BPS, because the price was $2.00 higher than at 2 other national big box stores.
Date published: 2013-10-14
Rated 5 out of
5 by
joshbirdblaster from
reloadingBeen having alot of fun making assorted loads with my new powder bushings. Would recomend anyone giving it a try!
