This SKU table contains a list of all SKUs available for the product. You can filter the list of items shown by selecting attributes.
Description
Reviews
Q&A
The TRUGLO® Magnum Gobble-Dot™ Sight is one of the #1 selling fiber-optic turkey sights. In-line, Tri-Dot sight mounts on rib with contrasting fiber colors in front and rear sights.
Model TG941XA: Fits most Remington, Browning Gold (camo), and Charles Daly Model TG941XB: Fits most Mossberg, Weatherby, Winchester (excluding SX3), and most populat 10 gauge models Model TG941XC: Fits most Beretta Field Grade, Benelli 20 ga, Browning Gold/A-5, Franchi, and Winchester SX3 models Model TG941XD: Fits most Benelli, Browning BPS, Ithaca, Ruger Red Label, Savage, and 8mm ribs
Web ID: 52186
Rated 4 out of
5 by
Graff12 from
Great, but you need to think of its purpose.There are most likely two type of users for these truglo sites which attach the ribbed section of your shotgun barrel, by use of either magnets or double sided tape. Those who shoot skeet/clays, and those for hunting. With this particular kit having the rear sights, it's obvious for hunting. Yes, these sights can come off too easily while hunting, as you go through brush, and the double sided tape is not commercial grade. However, when applying a sight to the ribbed section which has no mounting screw available, I recommend either RTV silicone, or Loctite 308. Both will do the trick, however silicone will be easier to remove if it was damaged or need replaced. Just plain simple and effective.
Date published: 2018-04-19
Rated 1 out of
5 by
Estimator2 from
Front Sight Did Not SecureBought this for my Winchester Sx4. I checked, rechecked, and checked one more time that my Sx4 rib rail was 1/4" width. Bought the 1/4" model # and the front site doesnt come close to 'clicking' on or staying put. Do I really have to put the sticky back tape down just to adhere and stick the front sight? The rear sight clicks and is a nice, tight fit...
Date published: 2018-03-20
Rated 5 out of
5 by
04Ozzie from
Sure Helps, Great ProductThis product fit my Browning Gold Mag perfectly and sure help with my sight plain with quicker on target scores with more shot in the kill area.
Date published: 2017-05-11
Rated 4 out of
5 by
benz33 from
Not bright enoughI have an older Gobble Dot sight on a turkey shotgun (TG94) and it has been very bright in dim light and light pipes look a bit larger than this model, also the red pipe is noticeably darker on the outside so maybe that is why it is dimmer? I compared both side by side and wish my purchase was brighter, Truglo should fix this. Yes it will work for turkey hunting but since it is plastic you will need to be careful going through the trees and brush. Based on my review I give it a conditional recommendation.
Date published: 2016-05-20
Rated 5 out of
5 by
Maxx77 from
GoodTakes a lot of the guess work out, I would recommend this sight.
Date published: 2016-05-15
Rated 5 out of
5 by
olretiree from
great product for turkey huntingi have used this product on both my turkey guns and is great for low light and my bad eyes.
Date published: 2016-05-01
Rated 5 out of
5 by
reknoy52 from
Great valueThis site is a great value for the average turkey hunter. Be sure to measure the width of your vent rib to assure correct size.
I installed it on my daughter's 20 ga. Remington pump with no problems. I always add a dab of super glue or gorilla glue as insurance.
I have had the same site on my turkey gun for over twenty years and it still functions perfectly!
Date published: 2016-04-15
Rated 5 out of
5 by
DawgZilla from
A bargain at twice the money!Fit my BERETTA like it was factory installed. Just snaps onto the vented rib and doesn't move, even after several Magnum turkey loads. Let's me easily aim down the barrel with more precision than a standard bead. It will serve its purpose just fine until I install my new red dot scope. Thanks, BassPro.
does a TruGlo Magnum gobble Dot sights fit a Mossberg 835 Ultra Mag shotgun
Asked by: Stan A
Thank you for your question. Unfortunately we do not carry the TruGlo Magnum gobble Dot sights that are compatible with your Mossberg 835 Ultra Mag.
Answered by: BPSProductSpecialist7
Date published: 2018-02-21
What size do I need for a stoeger m3000 shotgun?
Asked by: blake123
Hi, per Stoeger the rib size for the M3000 according to our technical data sheet is
Rib width---8mm---5/16”. Therefore, you will need the TruGlo Magnum Gobble-Dot Sight SKU: 1010929.
Thank you
Answered by: BPSResource7
Date published: 2017-06-02
I have a Remington Model 870 Super Mag what size would fit on its rib?
The description said the 1/4 inch but some people said it's too small and others said the 5/16 is too big, so kinda confused on which size to get. Thanks in advance.
Asked by: VPrince
If your rib measures 1/4 it should fit.
Answered by: 04Ozzie
Date published: 2017-06-02
Which model for A-5 with 7mm rib?
TG-941XC says it is for Browning A-5 and is for a 6mm rib, my A-5 has 7mm rib, which model do i buy?
Asked by: ILturkey
That model is for a Browning Gold shotgun, model TG941XA and TG942XA are for the A-5 shotguns with 1/4" rib. Remeasure your rib width.
Answered by: benz33
Date published: 2017-06-02
is this sight a clip on sight or the adhesive double sided glue
Asked by: blakethesnake
clip with double sided tape
Answered by: 04Ozzie
Date published: 2017-06-02
would this fit on a H&R 20 gauge shotgun?
Asked by: largemouth12
Measure your vent rib and choose appropriate model.
