Loading...
Your Cart ()
Close Panel
SE Sport™ High Performance Hydrofoil
- Compact design
- Improves handling and maneuverability
- 1-pc. high-strength copolymer construction
These compact, streamlined, state-of-the-art SE Sport™ High Performance Hydrofoils will improve handling and give you better maneuverability with a smoother ride. The Hydrofoil's crescent-shaped surface quickly funnels water for more thrust-cutting planing time for the quickest hole shot. The SE Sport Hydrofoil also keeps your boat on a plane at lower speeds. Features 1-piece, high-strength copolymer construction and control tip design. Also features Turbo Trac to enhance [Read More]
- Compact design
- Improves handling and maneuverability
- 1-pc. high-strength copolymer construction
These compact, streamlined, state-of-the-art SE Sport™ High Performance Hydrofoils will improve handling and give you better maneuverability with a smoother ride. The Hydrofoil's crescent-shaped surface quickly funnels water for more thrust-cutting planing time for the quickest hole shot. The SE Sport Hydrofoil also keeps your boat on a plane at lower speeds. Features 1-piece, high-strength copolymer construction and control tip design. Also features Turbo Trac to enhance thrust and control. For all outboards and stern drives 25 HP and larger except: Volov; Merc 50 Two-Stroke; Merc 40, 50, 60 Four-Stroke (but does fit BigFoot models); Merc Bravo II and III (but does fit those with 2 round anodes); Honda® 200, 225. Manufacturer’s lifetime warranty.
SE Sport Hydrofoil Clip sold separately and can be found through item search at item number 38-532-074-00
19 Questions | 46 Answers
Outdoor Answers
Get help about this item from fellow customers.
Ask your questions. Share your answers.
Expand All
Collapse AllDetails:
My Superguide v14 single console w/ 25hp 2stroke Mercury requires me to put more weight in the back of the boat when planing and running wide open. If I have someone else drive and I sit as far back on the boat as possible, the boat runs faster and engine 'frees up'. Changing pin position helps straight line running but then it cavitates horribly on the slightest turn. This seems so backwards to anything I've read or seen before. Will a hydrofoil help this situation???
(read all my Q&A)
Q:
0 answers
Has anyone installed the SE300 on a Yamaha 4 Stroke 80hp or 90hp? If yes, how well did it fit on the engine?
Details:
I have a 11'6" hard bottom inflatable rated for a 25hp but have a 20 hp 4-stroke. Bow rise is terrible, but gets on a plane in about a boat length. Coming off plane the extreme bow rise happens again and the transom dips low in the water and wants to take on water. Have as much cargo weight forward as possible.I have owned many boats but this is my first inflatable.Answers
A:
Look at Smart Tabs (SX9510-30 for your boat). All of your issues will be solved.Q:
2 answers
I have a Siverline Clasic Boat with the Mercruiser inboard 120 1969 witch hydrofoil would be ideal .
Answers
A:
Look into Smart Tabs ($129.99) at Bass Pro. Use SX9510-60
Top 250 Contributor
A:
I am not familiar with your boat. Here is the information that is listed.The 200 is smaller for a smaller motor being 8 - 40 hp. They should mention that in the catalog description.
The 300 is listed as being for motors larger than 40 HP.
The online description does list the motors that it will not fit as follows:
For all outboards and stern drives 25 HP and larger except: Volov; Merc 50 Two-Stroke; Merc 40, 50, 60 Four-Stroke (but does fit BigFoot models); Merc Bravo II and III (but does fit those with 2 round anodes); Honda® 200, 225.
You asked for "ideal" fit. The hydrofoil that is mounted on the cavitation plate is best when the boat has an odd shaped transom. If the rear of your boat is flat and wide enough to fit the "ideal" solution is to install automatic adjusting trim tabs.
Details:
As always, the product descriptions on this website are vauge and offer little information that could be helpful to the consumer.What is the difference between the 200 and 300 model? I have a 60hp Mercury.
Answers
Top 250 Contributor
A:
The 200 is smaller for a smaller motor being 8 - 40 hp. They should mention that in the catalog description.The 300 is listed as being for motors larger than 40 HP.
The online description does list the motors that it will not fit as follows:
"For all outboards and stern drives 25 HP and larger except: Volov; Merc 50 Two-Stroke; Merc 40, 50, 60 Four-Stroke (but does fit BigFoot models); Merc Bravo II and III (but does fit those with 2 round anodes); Honda® 200, 225".
A:
300- All sizes that have a cavitation plate larger than 5 inches wide, usually 40 horse power and up. Because the mounting holes on the SE Sport 300 are 4 inches apart, right to left (center to center), a 5 inch or smaller cavitation plate leaves less than ½ inch of metal from hole to the edge of the plate. The SE Sport 200 is recommended for cavitation plates 5 inches or less.200 model is recommended for outboards from 8-40 HP. It will fit all outboards and sterndrives larger than 40 HP except Mercury 40, 50, and 60 four strokes. There are some smaller outboards (down to 4 HP) that it will fit as well.
Details:
WILL THE SE SPORT HYDROFOIL WORK ON A I/O WITH 210HP?Answers
Top 250 Contributor
A:
Yes it will but with the obviously heavier boat that could handle that much power. You might also consider the auto adjusting trim tabs if they can be fitted to your hull.Details:
2001Answers
Top 250 Contributor
A:
The 200 is smaller for a smaller motor being 8 - 40 hp. They should mention that in the catalog description.The 300 is listed as being for motors larger than 40 HP.
The online description does list the motors that it will not fit as follows:
For all outboards and stern drives 25 HP and larger except: Volov; Merc 50 Two-Stroke; Merc 40, 50, 60 Four-Stroke (but does fit BigFoot models); Merc Bravo II and III (but does fit those with 2 round anodes); Honda® 200, 225.
A:
SE300 for 40 to unlimited HP engines.Details:
1993 ProCraft 180 Pro Bass/175 Mariner/4blade propAnswers
A:
Chine walking is caused by riding on the center (pad) of the boat with little or none of the boat touching the water on each side. Adding another device which lifts the boat even more from the center is more likely to make it worse. You will create a teeter totter efect, balancing on the center. Use Trim Tabs. Look at Smart Tabs SX9510-80 available here at Bass Pro. By the way, your top speed will increase about 5% or more.
Top 250 Contributor
A:
It did on my boats.A:
yes, ihave the identical boat, 225 mariner opti. cured the walking. would you know where to get replacement windsheild.
A:
A hydrofoil may offer some real performance improvements for chine-walking.Details:
Have a Pro 175 Alumacraft with a 50 hp Two Stroke Yamaha. Which of these would be the best fit?Answers
Top 250 Contributor
A:
According to the catalog description the 300 is the size for your engine.The 200 is listed for a 4 - 40 HP engine and the 300 is listed as being for more than 40 HP.
I think that the smaller 200 would work better on your boat. I do not know if the center slot on the 200 is wide enough for your motor.
If you order the 200 be sure that it will fit before you remove it from the plastic wrap so that you can return it.
It does state on the SE Sports package instructions that you can cut and make minor modifications the foil to fit without damage to the foil.
A:
SE Sport 300 = All sizes that have a cavitation plate larger than 5 inches wide, usually 40 horse power and up. Because the mounting holes on the SE Sport 300 are 4 inches apart, right to left (center to center), a 5 inch or smaller cavitation plate leaves less than ½ inch of metal from hole to the edge of the plate.Answers
Top 250 Contributor
A:
The foil fits on the cavitation plate on the motor or out drive, not on the boat.I assume that your description is that of a boat and not a motor.
The 200 is smaller for a smaller motor being 8 - 40 hp. They should mention that in the catalog description.
The 300 is listed as being for motors larger than 40 HP.
The online description does list the motors that it will not fit as follows:
For all outboards and stern drives 25 HP and larger except: Volov; Merc 50 Two-Stroke; Merc 40, 50, 60 Four-Stroke (but does fit BigFoot models); Merc Bravo II and III (but does fit those with 2 round anodes); Honda® 200, 225.
A:
The SE Sport 200 is designed for 8 to 40 HP engines.The SE Sport 300 is designed for 40 to unlimited HP engines.
Get help about this item from fellow customers.
Ask your questions. Share your answers.
19 Questions | 46 Answers
Customer Service
Live Assistance:
Daily 7am-10pm Central Time
Daily 7am-10pm Central Time
- 1-800-227-7776
- Contact Us
- Reward Points
- Gift Cards
Prices shown are in U.S. funds
All pages © 2006 - 2012 BPS Direct, L.L.C. All rights reserved.