Free Shipping on orders of $75 or more applies to economy shipping only to US and Canadian addresses on all internet or phone merchandise orders. (Canadian orders will be charged a $3.50 brokerage fee, duty and tax.) Excludes gift cards, orders shipped outside of the US and Canada, expedited or additional shipping and hazardous, special fees. Shipping charges on previous orders will not be reimbursed.
You may also order by calling 1-800-BASS-PRO (1-800-227-7776). Give the phone representative key code L5HS.
The TruGlo® Magnum Gobble-Dot™ Sight is one of the #1 selling fiber-optic turkey sights. In-line, Tri-Dot sight mounts on rib with contrasting fiber colors in front and rear sights.
Model TG941XA: Fits most Remington, Browning Gold (camo), and Charles Daly Model TG941XB: Fits most Mossberg, Weatherby, Winchester (excluding SX3), and most populat 10 gauge models Model TG941XC: Fits most Beretta Field Grade, Benelli 20 ga, Browning Gold/A-5, Franchi, and Winchester SX3 models Model TG941XD: Fits most Benelli, Browning BPS, Ithaca, Ruger Red Label, Savage, and 8mm ribs
TruGlo Magnum Gobble-Dot Sight
I put this sight on my Mossberg 835 shotgun and aiming could not be easier. The sight glows with only a wisp of daylight, and it is easy to line up the threedots and Blam! Right on target. Have only used this on paper targets and water bottles, can not wait till Turkey Season!
August 16, 2011
Simple and effective. Works as advertised. This product helps keep your head in position for good sight alignment even if you are in an awkward shooting position. Installation instructions could be a little more complete.
April 25, 2011
Easy to install and easy to line up. Adhesive tape stays put and offers a more consistent sight picture than a single bead.
January 24, 2011
Good for the price!
I go to alot of "Block shoots" and hunt turkeys with my Rem 870. These sights are good during bright light but not that good during low light. They are easy to install and for the price they can't be beat. They work well in most cases but not the best you could buy.
November 15, 2010
no,doesn't need to be,if you get the right one ,there's four diff sizes ,measure your vented rib width and order that width,don't go by the listings they listed mine as 1/4" and i measured it at 5/16" so a tip measure to be sure they are awesome sights and windage adj is not needed at all.hope i helped.
I had the same problem with my Benelli. The front sight is fixed and cannot be removed without cutting it off. You can just mount the sight behind the existing front sight and it seems to work fine. The new sight is a little higher on the barrel so no problem.
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.