Select the "Economy Shipping" option at checkout before entering promo code CELEBRATE. Some Exclusions Apply. Offer ends July 6, 2015.
Free Shipping applies to economy shipping only to US and Canadian addresses on all internet or phone merchandise orders. (Canadian orders will be charged a $3.50 brokerage fee, duty and tax.) Excludes gift cards, orders shipped outside of the US and Canada, expedited or additional shipping and hazardous, special fees. Shipping charges on previous orders will not be reimbursed.
You may also order by calling 1-800-BASS-PRO (1-800-227-7776). Give the phone representative key code L5JA.
couldn't be happier
Decided to try the bunk gulide ons because of the ease of installation. As advertised, they were easy to install. Seems like the boat is eaiser to launch and land. Don't know how long they will last, but at this point in time, i couldn't be happier with the product.
April 27, 2012
East to attach. Works great. A lot less effort to load and unload the boat.
September 23, 2011
Tie Down Guide On Bunk- COVERS!
I just got these delivered. To my suprise, there are not solid composite material, but PVC covers that go over your existing bunk lumber. These do not replace the bunks themselves, but are meant as an alternative to the normal bunk carpet. I'm sure they'll be as slippery as advertised, but based on the limited descriiption, I thought these would be a replacement for the bunks themselves. Now I have to consider the cost of buying the pressure treated lumber, as well as, the cost of these covers in total. Relative to the cost of replacment with the traditional carpeted wood bunks this might not seem the value I thought it was. Just make sure you underestand that these are only covers.
November 10, 2010
These replace my rotted carpeted bunks. They help launch and retrieve my 16 foot aluminum bass boat very nicely. Installation was a cinch. Very please with this product.
July 7, 2010
Slide on or off with less effort. Position the Bunk Glide Ons so that the two left and the two right bunks are facing inward and downward. Starting at the rear of the trailer, slide one of the Bunk Glide Ons onto the 2x6 lumber with the open side to the middle of the bunk board. Push the Glide On section onto the lumber until it is almost flush with the end of the bunk board (see Fig 2).
see my review. these are covers. I also have 7' bunks, so I'll have to cut and equivalent amount off of the ends of the two sleeves for each side so that the groved surfaces (that help self-center the boat) properly line up.
The diagonal grooves are what make them self centering. When installed correctly, the grooves point towards the midline of the trailer. This is supposed to keep the boat centered on the trailer while loading.
These are covers/sleeves that go over bunk board lumber and are attached to the lumber via the included stainless steel screws at the sides. There is no attachment at the top surface (that touches the boat) so you have to make sure that the covers are completely flat against the lumber or they will eventually crack at the side attachment points.
The ones that I bought fit nicely over two by four bunks. But mine were carpeted which I had to remove and clean all the staples off before I could mount them. They overall length is approximately 7 to 8 feet long for each bunk.
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.