Keep your spare tire in a handy spot with this Tie Down® Engineering Spare Hub & Tire Carrier. Spare hub fits 5 stud on 4-1/2'' spare with UHI 1750# hub with 1-1/16" and 1-3/8" bearings. Includes 5 stud pre-greased hub (w/bearings). Heavy duty steel carrier mounts both spare hub and spare tire. Fits all trailer frames up to 3" wide and 4" high. Security holes for optional cable & lock.
Very good product that I hope to never have to use. This was very easy to install and gives peace of mind when traveling in remote areas. You are covered if you get a flat,loose lug nuts, hub damage or wheel bearing problem.
July 23, 2012
Good- Works very well.
Bad- bolts are to long for my Tracker trailer, had to make spacers.
June 22, 2012
Good solution to an old problem.
Very satisfied with spare tire and hid holder. The trailer looks great with the spare attached. I like the fact that it rolls on impact with moving terrain. The mount angle keeps it out of the water during launch/recovery. Using the space tire as step is hazardous, so be careful of the mounting location. The u-bolts that came with it were too big for my Tracker/Trailstar rig. I got over that once I finally got it set up.
September 27, 2011
I bought this item to replace one on my boat trailer. The previous sat too low to the ground and would tear up the spare tire at RR crossing and dips in the road. The angle on the new Tire Carrier lifts the spare considerably and, with bearing system in place, when it does hit, it acts as another wheel on the trailer. Great purchase.
March 25, 2010
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.