Rated 3.5 out of 5 by 82
Rated 3 out of 5 by TheBargainHunter Was dissapointed, but i'll live
it doesnt fit the stock well. however, i put a safety pin on the opposite side and its fine.
April 24, 2009
Rated 2 out of 5 by stealthhunter14 terrible
waste of money.
yeas the hold you shells and bullets but like others have said it doesnt fit the gun stock very well.
April 17, 2009
Rated 2 out of 5 by CatfishingOnTheJames Could be better
As stated by others, this holder is made one width all the way down, so naturally it does not fit the tapered stock of a shotgun well. To get the one I purchased to fit properly I turned it inside out, and stiched from about 1 inch away from the seam back at an angle until my stiches met the factory seam about 2/3 of the way back.. Turned it back right side out and now it fits nearly perfectly. Seems the factory would have accounted for the taper of a stock in the manufacture. Next time I'll know better.
January 5, 2009
Rated 4 out of 5 by supremeweasel67 Holds what designed to hold
I have a couple if these on my different guns. I like it. Yes, I have had the same issues that others have had, being loose and sliding. (solved with some self adhesive velcro), not able to use with sling (solved by cutting small slit, then singeing the slit, slide over sling post), Have occasionally had rounds fall out (but they are held by friction with a piece of cloth, what do you expect). Maybe I did not expect as much from this as some other users, but it works for me, and I will keep using it.
December 26, 2008