RedHead® Antler Mounting Kits
Sale price:
Clearance price:
Starting at:
Sale starting at:
Clearance starting at:
Reg. price:
- Wood-grain finished plaque
- Pre-drilled
- Quick and easy antler mounting
- Gold nameplate
Rated 2.8 out of 5Â by 20
reviewers.
Rated 3 out of 5Â by KSLTigger Not too bad
I was disappointed by the poor instructions, especially the one item that said "as shown" and there was nothing shown. I found the hardware to be adequate with the exception of the long screws used to tighten on the bottom side - way too long. I ended up screwing through the back of the plaque and cutting off the excess.
I got what I paid for and the end result was not too bad for the little 8 point I was mounting.
February 3, 2008
Rated 1 out of 5Â by lonestararcher Very Poor Product
I bought this to mount a little 8 point that I shot. I fugured it was only 15 bucks so why not....big mistake. Poor directions, hardware was missing, and overall terrible product. I ended up liquid nailing the antlers to the plaque and putting the velvet cover (that dosen't fit) over them. Stay away from this mount kit!!!!
December 12, 2007
Rated 4 out of 5Â by Pinetree Good Value
I have purchased 7 of these kits over the past few years, and have mounted everything from a small 6 pointer to a P&Y buck on them. The key word is that it is a kit, and that you must cut both the skull cover, and the antlers to make them work together. I do believe that this mount is a good value for the money.
October 30, 2007
Rated 1 out of 5Â by Buck Hunter One size does not fit all
Purchased this product to mount antlers from my son's first dear. Mounting hardware is very fragile. Screws in kit twised off prior to being completely tight. "Cap" too narrow to cover area between antlers. Would not purchase this product again.
September 3, 2007
1 Question | 1 Answer
Outdoor Answers
Get help about this item from fellow customers.
Ask your questions. Share your answers.
 Expand All
 Collapse AllDetails:Â
the horns are seperate will they allach and hold
(read all my Q&A)
Answers
A:Â
The antlers would have to be connected under the skull cover some how. The cover is just a cover, all that holds it on is 2 tacks. Its not structural support for the antlers. The antlers have to be attached to the board in some way. If you can attach them to a board then you could put them on the mount and use the cove.1 of 1
Get help about this item from fellow customers.
Ask your questions. Share your answers.
1 Question | 1 Answer
1 of 1
