P-Line C21 Copolymer Fishing Line
Better Than I Expected
I bought a spool of 10lb test for a spinning reel, with rather low expectations of how this line would perform. But once I started throwing crankbaits with it, I was amazed at how smooth it came off the reel when I cast, and even more amazed by how far it would cast. I didn't get to reel anything in, but I did hang up a couple of times, and the line was MUCH stronger than I imagined it would be. Definitely better all-around than I expected. I've always been a loyal Stren user for mono line, but with this being a couple dollars cheaper than Stren, I could be convinced to convert. I've only been out once since I bought it, but my first impression of this line is very positive. At $5.99 for a 300 yard spool, you've got to give it a shot.
September 7, 2012
I've only been using it for month but its holding up very well and and have never had a break off.
July 31, 2012
After having an issue with Trilene line, i decided to try another line. I looked over a number of lines and decided to spool up my bait caster with the Pline 10 lb line. I went out today and cast this line numerous times including into 10-15 mph winds. No problems at all. To be fair I also had used KVD line conditioner on the line before using. Performed really well for a low cost alternative. Would by again for sure,
June 24, 2012
not the greatest, but it works
I saw this line while looking through the wall of products at the local BPS. New line, lets give it a try. It's not that bad, knot stregth is very good. But be warned, keep tention on it when you first spool it up. Like the poster below said, you let it loose and POOOFFF, you will have a mess. I put this on my bait caster 17#, when I cut the line from the spool and tied on a swim jig I noticed the line was unwound. I hooked the jig to my front door and walked it out until I had a tight line on the spool, about 40 yards. When I saw that I wasn't to impressed with it. I would recomend hitting it with some of the KVD line conditioner. After spraying on the KVD juice I let it sit over night. The stuff cast's like a dream, no memory from the spool at all, no coiling up on the reel at all. I have another new reel on the way, and I will be putting this on it. I have actually sprayed the spool of line with the juice, so I might not have the issue mentioned above. And no I don't have any ties with PLiNE.
February 26, 2012