For a limited time: no oversize shipping charge on rods!
Select the "Economy Shipping" option at checkout.
Free Shipping on orders of $50 or more applies to economy shipping only to US and Canadian addresses on all internet or phone merchandise orders. (Canadian orders will be charged a $3.50 brokerage fee, duty and tax.) Excludes gift cards, orders shipped outside of the US and Canada, expedited or additional shipping and hazardous, special fees. Shipping charges on previous orders will not be reimbursed.
You may also order by calling 1-800-BASS-PRO (1-800-227-7776). Give the phone representative key code L5HA.
Free positioner included for ease and versatility in hanging your reproduction or real skull mounts!
You put in your time to put that beautiful rack on the ground, now get that trophy on display up on your wall without a lot of fuss with the Skull Master Antler Kit from Mountain Mike's Reproductions. Say good bye to boiling and bleaching, this kit gives you all the hardware you need to attach a set of antlers to a great looking European deer skull in timely, no-mess fashion. Just 10 minutes. Great on all deer species. Simply detach your antlers flush at the pedicles or use shed antlers. Connect them to the appropriate size top section. Then connect the bottom portion of the skull to the top, hang, and enjoy! Kit includes injection molded skull sections, mounting screws, and instructional DVD. Made in USA.
Manufacturer model #: SKULLMASTER.
Attach antlers to a European deer skull in a timely, no-mess fashion
Comes with medium and large mounting sections to match antler set
Works with antlers of any diameter, whitetail or mule deer
Very good kit for the money.
Very good kit for what you pay. Easy instructions and looks good on the wall. Took maybe an hour to get the job done.
September 27, 2012
tried bleaching skull...this kit is much easier and better looking..take about..15 minutes to assemble .will definely use again
May 15, 2012
Not as good as it sounds
This product is decent for the money. But its not as easy as it sounds. It's difficult to hold the skull plate on the antler while you predrill the hole. You kind of have to get the angle right in the antler. If you had some kind of clamp to hold the two together it would help. Be careful if you are mounting smaller diameter antlers because if your drilling angle isn't just right you'll pop your hole right out the side of the antler as i did I don't think that 1 3/4 inch depth is necessary on smaller antlers. The screw head strips really easy. Also the skull is too shiny. I hit it with some fine grit sand paper and it helped take some of the shine off. Overall if you have the right tools and some patience it's not a bad buy but I won't be getting another one. Just doesn't look as genuine as a real skull mount.
November 18, 2011
I picked this up to mount a set of sheds I have from Montana. Overall good product would make a great gift.
November 13, 2011
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.