Free Shipping on orders of $75 or more applies to economy shipping only to US and Canadian addresses on all internet or phone merchandise orders. (Canadian orders will be charged a $3.50 brokerage fee, duty and tax.) Excludes gift cards, orders shipped outside of the US and Canada, expedited or additional shipping and hazardous, special fees. Shipping charges on previous orders will not be reimbursed.
Makes removing your Minn Kota® trolling motor a breeze! Made of high-yield composite construction that's impervious to corrosion. Low-profile design leaves the deck clear when the motor is removed. Bracket locks in over top of deck-mounted center puck.
Corrosion-resistant composite construction
Low profile design
Bracket locks over top of deck-mounted center puck
MKA-21: fits all Minn Kota Terrova, Power Drive, PowerDrive V2, or Pontoon Hand Control bow-mount trolling motors. MKA-23: fits all Minn Kota Fortrex, Maxxum, Maxxum Pro, Edge or All Terrain® bow-mount trolling motors. RTA-17: fits Minn Kota Riptide ST or Riptide SP bow-mount trolling motors. RTA-19: fits Minn Kota Riptide SF, Riptide SM or Riptide SE bow mount trolling motors.
Minn Kota® Composite Quick-Release Trolling Motor Mounting Brackets
I really like it, only have had it on the boat a short time
May 22, 2012
Worked well, but its expensive and the center disk should have been repositioned to allow for more flexibility in mounting. The bow of my boad tapers in and I had to modify the mount in order for the trolling motor to extend out far enough past the bow to clear the bumbers
April 28, 2012
Mounting Holes are same width as my old Motorguide
I bought this to see if the holes lined up with the built in mounting wholes that were used for the original equipment Motorguide trolling motor my old Bass Tarcker had.
I was bummed when I tried to mount my new Minn Kota (Power Drive v2) and there are a few choices for mounting holes but none lined up with the ones built into my boat (too wide).
The boat doesnt just have holes but countersunk welded bolt things..
This bracket (puck) lines up with the Motorguide holes in my boat width wise exactly. I used the stock mounting wholes on the front. I had to drill out the base plate since the old screws were a larger diameter and get ones with counter sunk heads, but it was worth it to use 2 of my original mounting wholes which are so close to the edge of the boat.
I did have to drill 2 new holes for the rear ones. But they were easy enough to get to.
I still cannot believe that no one has come up with an adapter bracket (at least that I could find) going from one to the other, etc.
This is expensive but I do like being able to take the troller off as well.
Hope this helps someone out there.
JC in AZ
September 30, 2011
Very easy to install, Works and looks great.
I would highly recommend.
June 29, 2011
I just bought a 2000 Wellcraft 16 fisherman and it had a RT55/SE on it. Wanting the I Pilot I quickly learned this wasn't just a head replacement. I had to buy the Whole thing new. Got a Riptide ST/55 w/ I pilot and planned to install. Now I found I dont have enough distance to clear the bow and was wondering 'for my boat will this bracket help me clear the front. Brian
I have attached the dimensions of the ST and the quick release plate you would have to measure and see if it fits. If you are still unsure you may have to contact the boat dealer to see how they normally install them. Thanks
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.