Fits into the bow or stern handle of your jon boat
For use with up to 35-lb. thrust trolling motors
This tough DuPont® nylon/fiberglass bracket allows anglers to mount a trolling motor without having to weld blocks to their flat-bottom boat. The Trolling Motor Bracket fits into the bow or stern handle of your jon boat for quick and easy removal or application. Angle is easily adjusted when in the bow-mounted position. To remove bracket, simply lift it out of the handle. Accommodates up to 35 lb. thrust trolling motors. Shaft hole: 2-1/2" diameter.
Rated 1 out of 5 by Ghug Jon boat motor bracket
Well after trying this for myself. I have now lost my trolling motor and bracket in the water. As well as my buddy that was trolling the boat in the water. It came right out really easy and he fell into the water and we couldnt find it again. It would be cheaper just to build something to mount on then this product.
February 23, 2009
Rated 5 out of 5 by LittleDink No Problems
I've used this bracket now for five years and its been an asset to my bass fishing. You mount your trolling motor and never have to unscrew it from the bracket. If you want to take your trolling motor off your boat you simply just pull up and it comes off with ease. Goes back on the same way. It does have alittle shake but thats on a high speed on your trolling motor. With it's ease of use I highly recommend it for your Jon boat.
April 19, 2008
Rated 1 out of 5 by jojo Not any good!!
I have purchased this product . Well to make it short, it broke the first time it was used and my trolling motor went in the water.
July 7, 2007
Rated 5 out of 5 by BP3623 Trolling Motor Bracket
I liked the product very much. It works well with my 12' jon boat.
November 10, 2006