Jon Boat Trolling Motor Bracket for Bow or Stern
Sale starting at:
Clearance starting at:
- Nylon and fiberglass construction
- Fits into the bow or stern handle of your jon boat
- Easy on/off
- For use with up to 35-lb. thrust trolling motors
This tough DuPont® nylon/fiberglass bracket allows anglers to mount a trolling motor without having to weld blocks to their flat-bottom boat. The Trolling Motor Bracket fits into the bow or stern handle of your jon boat for quick and easy removal or application. Angle is easily adjusted when in the bow-mounted position. To remove bracket, simply lift it out of the handle. Accommodates up to 35 lb. thrust trolling motors. Shaft hole: 2-1/2" diameter.
Rated 2.3 out of 5 by 27
Rated 1 out of 5 by skeeteroo i regret spending the money for it
it was a good idea behind this bracket but it will not work if your boat has anything other than an absolute flat straight surface above the handle. it is also a little too flimsy.
May 19, 2010
Rated 1 out of 5 by iggyfish waste of time
waste of time spend your money on lures does not work well with large electric motors
May 17, 2010
Rated 1 out of 5 want to return it
I bought this item thinking I could use it on the front of my boat but the first time it became obvious i shouldnt have bought it. first it is flimsy it moves back and forth when you go forward or reverse. second if you go over half speed forward it actually pops out of the handle. so Im back where I was before I bought it.
May 13, 2010
Rated 1 out of 5 by davf62599 Junk
This does not work very well at all. I ended up using it after having to bolt it in place and its still on the flimsy side. Don't waste you time and money.
April 18, 2010
Need Help? 7 days a week: 7am to 10pm CT or call 1.800.227.7776 anytime