Teflon® or nylon bearing surfaces for trouble-free operation
"Hot Foot" Throttle This is the original Foot Throttle that has been on the market for 20 years. Improves throttle control for all outboard and inboards. Aluminum casting to reduce weight and resist corrosion. Stainless steel hardware and non-sticking Teflon® or nylon bearing surfaces for trouble-free operation. A stainless steel spring returns engine to idle position when released. Equipped with toe clip for additional safety in extreme operating conditions. Provisions for additional return springing if required. Uses standard control cables for easy hook-up. Mounts directly to floor of boat with four screws (not included).
"Hot Foot" Adjustable Slide Mount Fits all Hot Foot models. Easily adjusts to any height person. All aluminum and stainless steel. Over 5" of adjustment.
Rated 5 out of 5 by bassmansam hotfoot i need.
My last boat had one in it. Then i bought another boat that didn't have one. two days out i need one. ( worth every dollar).
November 18, 2010
Rated 5 out of 5 by bigfishken A must!
Keep your hands (both of them) on the wheel...safer for high hp outboards.
November 1, 2010
Rated 4 out of 5 by SINGLEC Hot foot
I love my hot foot. The best part is that you can mount each ends of the main bracket and you can position the actual hotfoot anywhere on the bracket. The mount allows you to slid the hot foot back or forward based on your leg length. It was also easy to install. The only problem i got is the actual hot foot has a little room to slide back an fourth. Not much play but not completely tight. Overall a great product...
September 28, 2010
Rated 5 out of 5 by 05Rockcrawler Hot Foot Pro - GREAT PRODUCT
I would highly recommend this product to anyone with a bass boat. The installation was very easy and the product works perfectly. The combination of this with the Teleflex Marine Pro-Trim allows me to keep both hands on the steering wheel while controlling the gas, trim, and jack plate.
June 16, 2010
If your floor is thick enough or made for a hot foot it is much easier.You can find out by calling the boat company and asking.If not it requires fiberglass piece of wood and alot of skill before you can even mount it.If it is thick enough buy a motor manual(because you will have to remove the throttle cable,and sync-and link the hot foot with the carb linkage.the manual will give you step by step instructions.Including hot foot instructions).You can get away with putting throttle cable off motor in bilge area as long as it does not bind on anything and motor is free to turn easiely.this way dont have to remove control box,and you can hook up later if needed.Then get control cable about 3 feet longer than on boat. use 3M 5200 on screws for hot foot.follow instructions.
You would use the existing hand control to make your gear selection and the Hot Foot controls the throttle position. If you have a trim / tilt switch on your hand control it will still function as normal.