Free Shipping on orders of $75 or more applies to economy shipping only to US and Canadian addresses on all internet or phone merchandise orders. (Canadian orders will be charged a $3.50 brokerage fee, duty and tax.) Excludes gift cards, orders shipped outside of the US and Canada, expedited or additional shipping and hazardous, special fees. Shipping charges on previous orders will not be reimbursed.
You may also order by calling 1-800-BASS-PRO (1-800-227-7776). Give the phone representative key code L5HS.
G5 Outdoors T3 all-steel 3-blade mechanical maintains the flight profile of a field tip yet does incredible damage: 1-1/2" cutting diameter plus full pass-through with most bows. Spider Clips allow you to pre-tune blade deployment to your liking. No O-rings, no pre-deployment. Compatible with shoot-thru mesh.
All-steel 3-blade mechanical broadhead
Maintains the flight profile of a field tip
1-1/2" cutting diameter
Full pass-through with most bows
Spider Clips allow you to pre-tune blade deployment
G5® Outdoors T3 Expandable Mechanical Broadheads
Punched my first deer with them last weekend and the damage to the deer was unbelievable. The entrance wound was 3.5 inches across, no kidding I measured it. 184 lb 9 pt ran 20 yards with a shot that was a little back from a great shot.
They can be a little tricky to figure out with the spider clip, but well worth taking the time to learn because they really do fly like a field point through mesh and are just devastating upon impact. I will use these as long as they make them. Have to say bye to my beloved muzzy's that I've used for 20 years.
November 25, 2011
I've been a muzzy fan all my life. Bought an expensive crossbow with a very fast arrow speed. Realized that it would not shoot fixed blades consistently so I got these and tried them. IMMEDIATE LOVE. Shoots like a field point and expands great. I've seen a lot of reviews of people being upset that the arrow didn't pass through. When an arrow passes through, that MEANS that the arrow doesn't dump all of its energy into the deer. I just shot a nice seven point and the entry wound looked like a muzzle loader hole. The spider clips are a little difficult to understand at first, but it's not that hard.
November 17, 2011
wast of money
talked to 4 peopl before i bought these all said they were excelent ya right dont bump them on anything they fall a part spider clips are junk cost me a 12 point buck just as i released seen a blade hanging .next one 8 point buck perfict heart double lung did not open only went in 2 inch at 15 yards i shoot 65 lbs going back to cheaper brand and lot more kills
November 14, 2011
They look good and are very durable. But I've shot four deer this year and not one arrow passed through. (I pull 60 lbs.) I lost an outstanding buck despite a good hit.
November 12, 2011
If you are looking for a true mechanical. The switchblade by trufire is what your looking for. Disreguard all the reviews even the good one and see for yourself. They fly just like a field tip. It'll tack drive!!! They will not pre open in flight. Just make sure to use the same grain field tip and broadhead. I recommend the switchblade. Here is a pic. of the damage left behind the switchblade!
I'm sure you can but I wouldn't recommend it. Not because it's a bad broad head.But because crossbows from my understanding should be using heavier grain heads. These only go up to a 125gr. You go too light on a crossbow you will put to much stress on the bow. It's like dry firing it and it could break a limb. And I've seen guys bring there crossbows into the shops all the time with this same problem. All because they shoot to light of arrow and head.
With practice blades you can shoot almost any target. They should channel back just fine. With the blades it depends on your bow. If you have a speed bow going over 300 fps use a thicker target that has loose enough filing to push arrow through to other side. It would be very hard to remove these heads the way they went in. Take them through the back. But you will get great penetration so like I said plan on the bag thickness for how fast bow is.
I shot them into a redhead foam target. I use the practice blades so they do not open in the target. my problem is the head penetraits all the way through the target so i just take the head off then pull it back through, this saves from ripping the foam all out.
There is no need to shoot gators into your target at all! Use your field points and set your bow sights to them. The gator flies just like your field point. And yes if you do shoot them into your target you may not get them out
If you intend to shoot with the actual blades, use something you know you'll get a pass thru on, or something that will allow the tip to be exposed. If you shoot into a target and the tip lodges in the middle and you can't push it through the other side, there is no chance of getting it out the way it came
I'm not sure what minimum is , but I pass through deer every time with 70 lbs. My buddy gets pass throughs with 55lbs. . I shot a doe at 60 yards had pass through and even clean through one rib. But my bows ibo speed is 345.
I believe that shot placement will increase the chances of getting a good pass through. I have a Mathews Z7 set at 63 pounds and I achieved a pass through. But the newer bow are so efficient will increase the chances of a pass through. If you have the right set up bow poundage grain weight on the arrows and broad head and a good tuned bow with a good shot placement you get a pass through at almost any poundage on the bow
My family and friends have used these for years and it take very little energy to deploy these blades. They open very easily. I shoot the 125 grain broadheads at 70 pounds with 28 inch arrows and get compl ete pass throughs. Hope this helps, and as always God bless and good hunting!
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.