DOTLINE Motor Tilter
Sale price:
Clearance price:
Starting at:
Sale starting at:
Clearance starting at:
Reg. price:
- Designed for outboard motors without power tilt
- Cast aluminum body and legs
- Includes protective cushions and hand grip
Assists in tilting motor with less strain. Designed for outboard motors without power tilt. Adjustable arm fits shrouds of any size motor with hand holds. Cast aluminum body and legs with heavy-duty 1" diameter anodized aluminum tubing, includes protective cushions and hand grip. Heavy duty stainless steel arm will adjust to fit shrouds (motor cover) of any motor up to 75HP that has hand holds.
Rated 3.5 out of 5Â by 13
reviewers.
Rated 5 out of 5Â by Ricster Alittle Pricey
I purchased this item to help avoid being accidently pulled into the water as I am off balance when I have to pull my 40HP motor out of the water. I gave this product a try and was amazed at the simplicity and ease to pull my motor up and out of the water as well as putting it back; with absolutely NO off balance and have complete control. The only NEGATIVE I have on this item is the lower bar that attaches to the opening on the back of the motor cover. That aluminum pipe I know is to be adjustable but when you find tune that adjustment by tightening the screw; well it just doesn't hold the aluminum pipe in place. FIX: I drilled a hole where the screw is right to the other side and retrofit it with a bolt and locknut to secure the pipe in its place. Now it works just great.
April 12, 2011
Rated 1 out of 5Â by moneymalc no good
i bought this item on 8 25-2010 used it on my johnson stinger 70 1 pull and it broke i would not recommend to anyone
August 26, 2010
Rated 4 out of 5Â by Yorkie I like it
The device is sturdy and is definitely a big help for tilting my old 70 HP Johnson. You still need to exert a significant effort but a lot of that may have to do with the condition of my tilt mechanism.
I'd recommend the product.
August 9, 2010
Rated 5 out of 5Â by windy5651 WORKS LIKE ADVERTISED
I ONLY USED ONCE BUT WORKED VERY WELL, EASIER THAN EXPECTED
July 22, 2010
3 Questions | 9 Answers
Outdoor Answers
Get help about this item from fellow customers.
Ask your questions. Share your answers.
 Expand All
 Collapse All
(read all my Q&A)
Answers
A:Â
Look at the curvature of the shell/cowling on your motor. If it's significantly greater than in the picture (& most are), you will need modification to fit your motor. It can be done, but it will cost you extra.
A:Â
yes.my tohatsu 18 is of similar size and weight[electric start] so should be fine
A:Â
Yes, this is design to work fit shrouds of any motor up to 75HP with hand holds. Thanks!Answers
A:Â
yes .should be fine.tilter adjusts to fit various cowling lengths up to 40hp
A:Â
The DOT motor tilter will not work on Mercury 4 stroke motors.Answers
A:Â
If your Merc has a hand grip at the top rear of the cover it should be no problemA:Â
IT LIFTS A 48 HP JOHNSON WITH ONE HAND BECAUSE OF A BAD LEFT HAND.1 of 1
Get help about this item from fellow customers.
Ask your questions. Share your answers.
3 Questions | 9 Answers
1 of 1
