CMC PT-35 Tilt and Trim
- Designed for up to 35 hp motors
- Accommodates clamp-on or bolt-on motors without an adapter
- 11-1/2" wide with a 5-1/2" setback
- Weight: 24 lbs.
Customers have asked for a smaller version of the PT-130 and here it is! This is designed for 35 HP and smaller motors. This unit is 11-1/2" wide with 5-1/2" setback and only weighs 24 lbs. It utilizes the same hydraulic actuator and will accommodate clamp-on or bolt-on motors without an adapter. This saves you time and money!
Get help about this item from fellow customers.
Ask your questions. Share your answers.
The PT-35 will accommodate a tiller type motor. In fact most of the motors that go on the PT-35 are tiller motors.
The most important thing about mounting a motor to the PT-35 is the width requirements. We have made the PT-35 so small and compact, some motors are too small wide to fit on the PT-35. Please measure the width of the clamp feet (outside to outside measurement) and any bolts that mount the motor including the head of the bolts. If the measurement is 11" or less, that motor will fit. If the measurement is more than 11", you would have to go to the PT-130 which will accommodate any motor up to a 130 H.P.
1. One hydraulic PT-35 unit.
2. One wire assembly with toggle switch.
3. One switch plate and rubber boot.