Never lose an arrow again! Replace your original internal mount nocks with Burt Coyote Lumenok™s. Lights up automatically when seated against a carbon or aluminum arrow shaft. Stays lit for up to 40 hours. No magnets, no glue, no switches or moving parts. Light can be disengaged by backing nock out of arrow shaft.
Burt Coyote Lumenok™ GT Lighted Nock for Gold Tip Arrows
Have used a couple different brands and these are the best i have found. They work time after time with no problems
September 28, 2012
These Lumenok's work just as advertised and fit the arrows perfectly. Just make sure you buy the right one for the arrows you shoot.
September 6, 2012
I just put these on my Ted Nugent Gold Tip arrows matched with a Diamond Razor Edge bow (set at 60#s) that I just bought last week and they are phenomenal. I was shooting these in the shop and they worked every shot. I have put about a 150 shots on them already and I have not had a failure yet! You just have to make sure you have the right arrow for them or else you will have a frustrating mess! Awesome and very cool can't wait to see one pass through a deer!
August 7, 2012
My wife purchased the lumenok for me for fathers day . I was absolutely amazed at how easy they are to use and how tough they are . I have tried other brands such as the nocturnal and tracer , they don't compare to the lumenok . The lumenok is brighter and a lot easier to use . I'll never use anything else!!!
July 12, 2012
don't waste your time or money only 1 of three would light for me. I bought nockturnal for my carbon fury arrows and they are much brighter and light every time. only draw back is batteries are not replaceable, but they are cheaper and should last several seasons.
Go to an archery shop and get your draw length measured. Your bow needs to be set to your draw length as well. I measure my draw length on the bow I will be hunting with after I have set the draw length on it. I have a 29" draw length on my PSE but I measured and cut my shafts to 28.5" because the rest I use allowed me to shorten my shafts by .5". As for cutting them I would have a shop do it with an arrow cutter when you check your draw length. Carbon arrows can splinter if the blade is to course or to slow and an arrow saw will insure a square cut to the shaft. Precision, Precision, Precision! Most places will cut the shafts for no charge at the time of purchase and install the correct inserts for no charge.
To turn off pull the nock out from the end of the arrow just past the two metal prongs on the lumenok. Contact between the two prongs and the arrow complete the circuit to allow the light to work. The only draw back to these is that you cannot replace the batteries. I have a few that the battery is dead and those are the ones i use to practice with.
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.