Free Economy Shipping on orders $75+

Select the "Economy Shipping" option at checkout.

Free Shipping on orders of $75 or more applies to economy shipping only to US and Canadian addresses on all internet or phone merchandise orders. (Canadian orders will be charged a $3.50 brokerage fee, duty and tax.) Excludes gift cards, orders shipped outside of the US and Canada, expedited or additional shipping and hazardous, special fees. Shipping charges on previous orders will not be reimbursed.

You may also order by calling 1-800-BASS-PRO (1-800-227-7776). Give the phone representative key code L5KM.

Bohning Ferr-L-Tite Cool Flex Carbon Shaft Adhesive


Sale price: Clearance price: Starting at: Sale starting at: Clearance starting at: Reg. price:

Quantity Price & availability

12 Gram

  • $7.49

  • SKU: 1798573

  • In Stock
  • Add to Cart

    Add to Wish List

  • Check Store Availability

Bohning Ferr-L-Tite Cool Flex Carbon Shaft Adhesive offers low-temp hot melt for carbon shafts. Instant full strength setup in cold water. Easy to apply; heat reversible; 12 gram stick will glue approximately 144 inserts.
Manufacturer model #: 1308.

  • Easy to apply
  • Heat reversible
  • Low-temp hot melt for carbon shafts
Bohning Ferr-L-Tite Cool Flex Carbon Shaft Adhesive 4 5 2 2
doesnt like hot weather. Ok so I bought some of this to install some inserts and easton uni bushings. It is VERY easy to use, goes on well, works good. it just doesnt like hot weather. Its 100F right now in missouri and after shooting for 20 min the inserts started turning and wanting to pull out. If you were shooting inside, or were it stays below 80F most the time it would be great. Now it did work very well on my bushings. which to be honest was the main reason I bought it. I didnt want my bushings glued in permanently and like the fact you just put this in boiling water to remove the bond. this is great if you shoot pin nock and pin bushing..because if you bust one just heat it up and remove the broken bushing. The bushing doesnt get pulled on, or get much impact, so the bond stayed good in hot weather. Basically, Great to use on pin nock bushings, or collars or uni bushings. in all weather. Doesnt work on inserts in hot weather at all. Would work for indoor shooting, or cooler weather. Easy to use, and remove. I will still buy it just for bushings. September 2, 2011
Great This worked great, after putting in incert, I cooled it in cold water, then shot it with no problems. Then I placed on a broadhead, put it in boiling water, and tuned the broadhead how I wanted, back in cold water, then shot it No Problems July 12, 2011
1-2 of 2

Need Help? 7 days a week: 7am to 10pm CT or call 1.800.227.7776 anytime