Free Shipping on orders of $75 or more applies to economy shipping only to US and Canadian addresses on all internet or phone merchandise orders. (Canadian orders will be charged a $3.50 brokerage fee, duty and tax.) Excludes gift cards, orders shipped outside of the US and Canada, expedited or additional shipping and hazardous, special fees. Shipping charges on previous orders will not be reimbursed.
You may also order by calling 1-800-BASS-PRO (1-800-227-7776). Give the phone representative key code L5HS.
Bass Pro Shops® Outboard Boat Motor Support Bracket
MOTOR BRACKET - TRANSOM SAVER
Very poor quality. Did not support my 90 Merc, although said it was rated to 100 HP.
June 6, 2012
Cheap and works great..
this does what it is made to do... either mounts to trailer lower, if you have a center roller you can also mount that way, i always used a little black duct tape on the end so the lower unit didn't get scraped up, it lasted me 3 years, you must with any T-Saver, you need down preasure to keep the motor from turning while driving,
as for no instruction...yikes, i think i be scared to be on the lake with any boater that has to figure this out, but advise, look at a boat at the pro shop or elsewhere and see how it is installed, or better yet ask for instruction from one of the friendly and help employees at the pro shop to instruct you how to install..
look at my photos below, maybe this might help some of the rookie out there, alos NOTE: the lenght you want...should be about the same tilt as if you where running full throtle with max trim...
I just UPGRADED to a new one with the rubber feet, very nice, also the spring loaded may sound good in theroy, but i not sure how letting the motor bounce up and down is a great idea.. just my opion on that.. but may work fine.. but the point of a saver is to SAVE the Transom from the motor bouncing around and taking a beating from the bumbing roads in New England......
Nitro Boats are the best BANG FOR THE BUCK..
my knowledge of boat has been over 30 years, I own a 2011 Z-9 dual console (Candy Apple Red)and a 2008 Tracker Pro Team 175 TXW special edition (Black) 30th annv. Edition
August 18, 2011
Just purchased this support bracket. No instruction with it, had to take it apart and study it. I'll update thIs review after a few trips to the lake.
April 6, 2011
Very poor quality
This support will not keep the motor from flopping side ways. I would never purchase another cheap stabilizer. Spend the money for a quality support !
March 17, 2011
Bass Tracker Pontoon Boat, 19 foot party barge, need 45" support bracket
1 year, 8 months ago
Top 250 Contributor
since with a pontoon it is about support not clearance like a regular boat trailer..
couple options for you, just cut a new piece of square tubing to the lenght you need to make it long and stiff use a heavier tubing, also if you don't go far and often, due what most due since the pontoon trailer are so high off the ground, put the motor all the way down, turn it all the way one way and use a rachet strap from the traler around the motor back to the trailer, all your trying to due is stop the motor from bouncing up and down and putting strain on the transom of the boat, just make sure your lower unit is still at least 18" or more off the ground and you are good to go.... done this hauling the potoon 120 miles each way twice every year......work great...
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.