For a limited time: no oversize shipping charge on rods!
Select the "Economy Shipping" option at checkout.
Free Shipping on orders of $50 or more applies to economy shipping only to US and Canadian addresses on all internet or phone merchandise orders. (Canadian orders will be charged a $3.50 brokerage fee, duty and tax.) Excludes gift cards, orders shipped outside of the US and Canada, expedited or additional shipping and hazardous, special fees. Shipping charges on previous orders will not be reimbursed.
You may also order by calling 1-800-BASS-PRO (1-800-227-7776). Give the phone representative key code L5HA.
Bass Pro Shops® Dual Flow Motor Flusher provides maximum water flow into both intakes, allowing you to flush your cooling system quickly and effectively with a garden hose. Also provides a great way to test run your boat out of the water before hitting the boat ramp. Fits most outboards and I/O Mercury®, Johnson/Evinrude®, Yamaha®, Chrysler®, Force®, Honda®, Nissan®, Suzuki®, and Tohatsu®.
Bass Pro Shops® Dual Flow Motor Flusher
These are the best
I have a Mercury Force 120 hp outboard and these are the best muffs for it! Others that are made out of plastic are junk, they slide off and don't push enough water in if you don't hold them on. These are perfect. The cups are big enough to cover all holes, they push more than enough water through and the metal brace keeps them from sliding off. Well worth the money, has made life a little easier!
September 10, 2009
Could be better
Normally, this item should be great for saving time and hassle when flushing your motor. For some reason, however, I have had some bad luck with its quality of construction. I received my first one, and quickly discovered that the hard plastic threaded hose fitting was cracked, so I returned it for a replacement. Then, I later received the replacement, only to find that it too was broken in the exact same place! So, I'm not sure if this problem was simply limited to some of Bass Pro's stock, or if the product is defective across the board. Either way, just be sure to immediately check this fitting, even before you open the package. Even so, minus this defect, I think this flusher is a great investment for the price!
November 9, 2006
Great for two reasons
Now I can run my motor out of the water for testing with this hooked up, and I can flush it out properly.
July 21, 2006
We will not share your email address or the recipient's email
address. We make no use of the email address or information contained in
these greetings except to complete the service as you have requested.