Bass Pro Shops 2000 lb. Dual-Drive Trailer Winch
Planned obsolesence is built right in.
It's rather frustrating to upgrade a winch to well beyond the needs of your boat, only to have it fail in the same manner and place that your previous winch did.
Thinking this was a tougher winch and not wanting to replace one every yearI I upgraded to this 2000LB dual-drive winch, for my 19' Bayliner; a boat that should only need the smallest winch on the market. This winch lasted about 2 dozen times and that's when the bolt that locks the gears and changes the direction of the rotation, sheered off and rendered the winch useless. This isn't a part that I have been able to replace. (It should be a 1/4-20 4" bolt) But this "replacement" doesn't allow it to be tight enough and the locking teeth won't hold under the strain of being tight. You cannot get this part replaced and you have to buy a whole new winch; all because of a 50 cent part.
This could be avoided if the winch manufacturer used aircraft grade, or hardened steel pins or bolts on the parts that are subjected to the most stress, but this would be the smart approach. I have no doubt this is a problem for others (as it's happened to me twice) and that the winch manufacturer is knowledgable about this lack of quality. They CHOOSE to ignore quality and use inferior parts, as part of their "planned obsolesence".
Bass-pro should sell a winch that lasts a lifetime with normal wear and tear, and help boaters to spend their time boating instead of repairing a part that should never have broken in the first place.
August 2, 2006
poor product quality
I was very dissapointed in the overall poor quality and life of this BPS product. I first tryed the BPS 1,200 # and 1,600 # BPS trailer winches with even worse results. I finally gave up and ordered a Fulton brand trailer winch from Bass Cat which I am very pleased with. It is stronger, built better, and even has a plactic cover over the gears for safety while in use.
July 27, 2008
I purchased this winch to replace the one on my trailer. It is rated for 2000 lbs, which is more than my old one. I can not winch my boat on to the trailer like I should. The crank is too short and the drum is too small; thus, there is not enough leverage. Several times, after cranking as hard as I could, the ratchet mechanism slipped and let several inches of the strap back out.
This trailer winch is bad news. Sure wish I was not stuck with it.
I have an 18' fiberglass boat with a 140 hp motor
September 24, 2014
I tried to install this winch on my trailer and had nothing but trouble. With the design of my trailer, it was best to continue using a u bolt for the front of the winch. There are pre drilled holes for this application but there is a big design flaw. The spring for the lever that controls the direction for the gear drive can't clear the threads. Even with low clearance of threads, it still didn't work. As soon as I installed the u bolt and tried to switch positions, the spring sheared off renendering the winch useless. Spend your money elsewhere.
August 29, 2007