yes if it is a 45 or 44 cal.

Pellets in inline, but side ignition muzzle loader have to use granular. pellets are quicker load and every pellet should be close to the same measurement. more consistency.

I'm sorry I cannot speak for the granule as I've never used them. However, I've used four boxes of the pellets over the last several years and have LOVED them. I use powerbelt ammunition and I've always had equal burn and accuracy out of this combination. Hope this helps.

No, but 50 cal will work. if it is an inline with 209 primmer.

only if it is an inline.

yes you can, but make sure your box reads 45/50 which is the caliber/grns

If you are using an inline muzzle loader (this means that the primmer is in a strait line behind powder or pellets) clean the weapon then fire two to three primmer to clear out the hole in the breach plug (where the primmer is) after a few seconds put in the pellets or powder then projectile. using a bullet starter push the bullet down a few inches then with ram rod seat the bullet all the was down until it is up against the powder. when you are sure you are at the powder mark the rod so you will be consistent with every load. now put the primmer on and you are ready to shoot. This is a very brief description of what to do you need someone to help you when you shoot the first time. If something is not done correctly people can be hurt. most gun shops can help.

ok step one clean your barrel, free of extra lube or build up. use the JAG with a dry patch, go down and up a few times

JAG= the ridged cylynder usually on the end of your ram rod.(picture 1)

drop in the pyrodex pellets. (2 is 100GR 3 is 150 GR) with the dark black side down.

slip in your bullet. i reccomend the non saboted hollow point ( i reccomend the hollow point powerbelt ) easy to slide down.

before you shoot for the first time be sure you are all seated in the barrel. MARK YOUR RAM ROD WITH A FULL BARREL this will help you remember if its loaded at the range or not ( there will be times you forget)

if your gun is a 209, open the BREECH and insert your primer.

209 = shotgun primer. (picture 2)
breech. the hindge area or area your cap is put in(picture 3)

now pull back your hammer. aim and fire!

once you fire.

if your in the field and shot a deer. run your ramrod down the barrel one or 2 times to stamp out any embers. embers will make your powder go poof!

then proceed to load.

if sighting in. after every shot. clean your barrel useign standard cleaning practices. why? because in the field your not shooting with a dirty hot barrel. so at the range use a clean cold barrel every time you shoot. takes longer. but more on target.

i hope this has helped. remember know your target and beond. these are rifles not shotguns.

now im not sure if you were refering to muzzy its self or now that i see about it working in handguns. in handguns i do not know. i assume but ask your lokal shop for more info. they are verry closely related.

there are many online forums that can help you. due to guide lines i can not specify a website i and thousands of others frequent but you can search on google for a forum to belong to.